FZW32-12 (40.5)outdoor MV isolatingvacuum load switch is a newtype of load switchwhich is the integration of mature experience of domestic existingload switch and advancedtechnology design of external.This load switch is composedof isolating switch,vacuum interupter and operating mechanism and other parts.By using the principle ofvacuum interrupter,with strong arcing ability,reliableperformance,long service life,small volume,no explosion danger,no pollution etc advantage.Theproduct can be used in transmission and distributionsystem ofelectric power,metallurgy,mine,chemical industry and other departments as control equipment,especially suitable for frequent operation place

GN19-12 indoor MV isolation switch series MVswitch equipment used for rated voltage 10kY,AC 50Hz and below power system,equipped with CS6-1 type manual operating mechanism,open,close the circuit in the case of no load,voltaged.There arederivatives such as anti pollution,highprototype andadded chargeddisplay devicetype,etc.

The GW9-10G of outdoor MV isolator switch is the high voltage switch equipment of single phase AC50Hz.The product issuitable for power system with rated voltage 10KV to make or break power supply under circumstances of with voltage andnomload.
C The isolator adopts isolatedrodto operate.
C Standard:IEC60129

Operating conditions
1.The altitude above sealevel:2000m
2.The ambientair temperature:-40℃~40℃ wind speed does not exceed 35m/s.
3.The earthquake intensitydoes not exceed 8 degrees
4.The working situation is without frequentviolent vibration.
5.The installation site ofordinarytypeisolator should be kept awayfromgas,smoke chemical deposition,salt-spray fog,dust and other explosiveand corrosive maters that affect seriously insulation and conductioncapabilityof the isolator.
6.Pollutioni-proof type isolatoris applicable to severe filthyconduction area,however,it shouldn’t be anyexplosive matters and matters causing fire.

 This type of current transformer is casting resin,fully enclosed and post type product.It is used for metering electric energy andcurrent,relay protection in the electrical system.

Standard:IEC61869-2