Products Manufacturers | China Products Factory & Suppliers - Part 26

Products

Products

Product Category

YCM3LE Leakage MCCB

YCM3 Series moulded case circuit breaker,is new products,with small compact, modular,high break,double breakpoints,zero arcing,green environmer protection.

Suitable for AC50Hz,60Hz,rated operating voltage 690V and below, rated current 125A to 1600A distribution network,used to distribute electrical energy and protection lines and powersupply equipment from overload,short circuit and undervoltage failure hazards.

It can also be used as a non-frequent conversion of the line under normal conditions and in theinfrequentstart of the motor
YCM3Y Molded Case Circuit Breaker(Electronic)

YCM3 Series moulded case circuit breaker,is new products,with small compact, modular,high break,double breakpoints,zero arcing,green environmental protection.

Suitable for AC 50Hz,60Hz,rated operating voltage 690V and below, rated current 125A to 1600A distribution network,used to distribute electrical energy and protection lines and power supply equipment from overload,short circuit and undervoltage failure hazards.

It can also be used as a non-frequent conversion of the line under normal conditions and in the infrequent start of the motor.
YCM3E Molded Case Circuit Breaker(Electronic)

YCM3 Series moulded case circuit breaker,is new products,with small compact, modular,high break,double breakpoints,zero arcing,green environmental protection.

Suitable for AC 50Hz,60Hz,rated operating voltage 690V and below rated current 125A to 1600A distribution network,used to distribute electrical energy and protection lines and power supply equipment from overload,short circuit and undervoltage failure hazards.

It can also be used as a non-frequent conversion of the line under normal conditions and in the infrequent start of the motor.
YCX8 Series DC Combiner Box

1. Overload protection
2. Short circuit protection
3. Controlling
4. Used in residential building, non-residential building, energy source industry and infrastructure.
5. According to the type of instantaneous release classified as follows : type B(3-5)ln, type C(5-10)ln, type D(10-20)ln
YCM7YV MCСB

General

YCM7YV series electronic plastic case circuit breaker (hereinafter referred to as: circuit breaker) is suitable for low-voltage power grids with AC 50Hz, rated insulation voltage 800V, rated operating voltage 400V and below, and rated operating current up to 800A.

The circuit breaker has overload long-delay inverse time limit, short-circuit short-delay inverse time limit, short-circuit short-delay fixed time limit, short-circuit instantaneous and under-voltage protection functions. Under normal circumstances, the circuit breaker is used for infrequent switching of circuits and infrequent starting of motors.

This series of circuit breakers has isolation function, and its corresponding

symbol is

Standard: IEC60947-2.
YCM8YV Series MCCB Accessories

General

The rated insulation voltage of YCM8YV series electronic liquid crystal molded case circuit breakeris 1000V. It is suitable for the distribution network with AC 50Hz, rated voltage of 400V and below and rated current up to 800A.

Under normal circumstances,the circuit breaker can be used for infrequent switching of circuits and infrequent starting of motors.

It can protect the circuits from overload and short circuit, as well as over-voltage, under-voltage and phase loss.

Standards:IEC60947-2
YCQ9B-125 Automatic transfer switch（CB class)

General

This series of Automatic transfer switch is suitable for AC 50Hz/60Hz, rated working voltage 230V/400V and below power distribution and control circuit.The current up to 63A. It is mainly used as the main switch of terminal electrical appliances, and can also be used to control various types of motors, low-power electrical appliances,lighting and other places.

Standard:IEC60947-6-1
YCQ9Ms Automatic transfer switch

General

YCQ9Ms series dual power automatic transfer switch is suitable for power supply system with AC 50/60Hz, rated working voltage AC400V, rated working current 800A and below.

It is possible to select and switch between two power sources according to requirements, ensuring uninterrupted operation of key power sources. When one power supply has overvoltage, undervoltage or phase loss, it will automatically

switch to another power supply or start the generator.

Built-in RS485 communication interface, communication protocol MODBUS-RTU, realize real-time data upload, remote data configuration and status monitoring, as well as remote control, telemetry, remote control and remote adjustment functions.

Mainly used in hospitals, shopping malls, banks, hotels, high-rise buildings, fire protection and other places that do not allow long-term power outages with uninterrupted power supply required.

1. Can work in the environment of -5°C~40°C

2. The altitude of the installation site does not exceed 2000m

3. When the highest temperature is +40°C, the relative humidity of the air should not

exceed 50%

4. Higher humidity is allowed at lower temperature, 20°C~90%

Standard: IEC 60947-6-1
YCQ1F series excitation type Automatic Transfer Switch (ATS)

The YCQ1F series automatic transfer switch consists of a load isolation switch (without overload and short-circuit protection mechanism) and an intelligent

controller. The switch adopts an excitation type transfer mechanism, which provides faster switching speed.

It also employs a new microcomputer control system for intelligent monitoring and control, strong electromagnetic compatibility, long-term continuous operation, and stability and reliability.

The split-type product can be equipped with an LCD display controller, which is easy to operate, has clear indications, and provides a user-friendly human-machine interface.
YCQR-63 Mini automatic transfer switch（PC class)

YCQR-63 automatic transfer switch is a PC class infrequent change-over switch, with two-station design (commonly used for A and standby for B), suitable for AC systems with AC 50-60hz and rated current 6A-63A.

The main function of the automatic transfer switch is when the main power (common power supply A) fails, the ATS will automatically switch to the backup power (Backup power supply B) to continue working (switching speed <50 milliseconds), which can effectively solve the troubles caused by power outages.
YCQ4E/YCQ4R PC type Automatic Transfer Switch

The dual power automatic switch is a newly developed miniature household power switch,which is mainly used to test whether the main power supply or

standby power supply is normal.When the normal power supply is abnormal, the standby power supply starts to work immediately,which ensures the

continuity,rel iabi l ity and safety of power supply,This product is special ly designed for household rail installation and is specially used for Pz30 distribution box.
YCQ9E Automatic transfer switch

General
YCQ9E series automatic transfer switch, rated working curent 16A to 630A,to be used in pow- er systems for ensuring the continuity of the supply, by transfering a load between two power supply sources. The switch has three working posions of “Main ( I ) cosing”, “Standby ( II )
closing” and “Double-of (0)”, which can be used for fire-fighting linkage and infrequent con-
necion and disconnecion of power supply systems. Mainly used in hospitals, shopping malls, banks, chemical industy, metalurgy, high-rise buildings, military facilities and fire-fighting occa- sions where power failure is not allowed.
Standards: IEC 60947-6-1

<< < 23 24 25 26 27 28 29 > >> 26 / 43