Projects
Solutions
Services
News
About Us
JDZX8 Voltage Transformer
-
Product Overview
-
Product Details
-
Data Download
-
Related Products
JDZX8 Voltage Transformer
Picture
JDZX8 Voltage Transformer
JDZ8-3, 6, and 10 voltage transformers are single-phase epoxy resin cast insulation fully enclosed products, suitable for use in power systems with non effectively grounded neutral points at rated frequencies of 50HZ or 60HZ and rated voltages of 3KV, 6KV, and 10KV for energy metering, voltage monitoring, and relay protection
Standards:IEC 61869-3
Contact Us
Product Details
JDZ8-3, 6, and 10 voltage transformers are single-phase epoxy resin cast insulation fully enclosed products, suitable for use in power systems with non effectively grounded neutral points at rated
frequencies of 50HZ or 60HZ and rated voltages of 3KV, 6KV, and 10KV for energy metering, voltage monitoring, and relay protection
Standards:IEC 61869-3
Technical data
The voltage transformer is in accordance with GB1207 and IEC186 standards…
Note:
If user’s data goes beyond the above-mentioned scope. they may be subjected to an agreement between manufacturer and purchaser. Rated put and its relative accuracy class are alternative.
Overall and mounting dimensions(mm)
Write your message here and send it to us
Related Products
-
FZN21FZRN21-12 Load SwitchSelection Operating conditions 1. Altitude: no more than 1000m; 2. The environment temperature: upper limit +40℃, lower limit -30℃; 3. Relative humidity: daily average value is not greater than 95%, monthly average is not greater than 90%; 4. Saturated steam pressure: daily average value is not higher than 2.2×10 -3 Mpa, monthly average is not higher than 1.8×10 -3 Mpa; 5. No severe vibration, no corrosive gas, no fire, no explosion danger place.... -
GN19-12 Indoor isolation switchGN19-12 Indoor isolation switch GN19-12 indoor MV isolation switch series MV switch equipment used for rated voltage 10kV, AC 50Hz and below power system, equipped with CS6-1 type manual operating mechanism, open, close the circuit in the case of no load, voltaged. There are derivatives such as anti pollution, high prototype and added charged display device type, etc. Technical data Model Rated voltage (kV) Maximum voltage (kV) Maximum current (A) 4S ther... -
PRW1 Drop-out Fuse● Outdoor drop type fuses are suitable for 35kV and below voltage and frequency 50Hz power systems, used for overload and short circuit protection of transmission lines and power transformers, and for breaking and closing rated load current. ● The drop type fuse consists of an insulation bracket and a fuse tube, with static contacts installed at both ends of the insulation bracket and dynamic contacts installed at both ends of the fuse tube. The fuse tube consists of an inner arc extinguishin... -
HYWZ Surge Arrester● The zine oxide arrester is the most advanced over-voltage protector in the world;Due to make the risistor disc of core componet mainly adopt zine oxide arrester.Compared with the conventional silicon carbide arrester, this presciption of theproduct improvesgr-eatly the volt-Ampere characterisics of the resistor disc andincreased through-current capability at over-voltage so as to dring arad-icalchanges for the characteristics of the arresters. ● Under the circumsta... -
XRNT Current-limiting Fuses for Transformer Pro...● lt can be used in indoor system of 50HZ and rated voltage of 3.6KV， 7.2KV， 12KV， 24KV，40.5KV;Used together with other switch facilities such as loading swithes， vacuum contactors，it can protect electric transformers and other electric facilities against overloading or circuit break. It is also a necessary accessory for high-voltage switchbox，circular circuit cabinet，high / Low voltage top-loading transformer substation. Selection Technical data Ty... -
GW4 Isolation SwitchGW4 Outdoor Isolation Switch GW4 outdoor MV isolation switch is used for three-phase AC 50Hz outdoor high-voltage electrical equipment, switching of lines under high-voltage no-load conditions, and electrically isolating electrical equipment such as high-voltage busbars, circuit breakers, and live high-voltage equipment for maintenance voltage lines , can also be used to switch small capacitor or inductor current. When the knife is in the normal open circuit position...
Copyright © 2022 CNC ELECTRIC GROUP CO.,LTD. All Rights Reserved.
Hot Products - Sitemap
Mccb Microprocessor Based, 250amp Mccb Circuit Breaker, 3p Ac Mcb, 6a Elcb, 3 Phase Starter, Mpcb,
Hot Products - Sitemap
Mccb Microprocessor Based, 250amp Mccb Circuit Breaker, 3p Ac Mcb, 6a Elcb, 3 Phase Starter, Mpcb,