Working Conditions 1. Power capacitor should confirm left voltage reduce to rated voltage 10% to input again after the power was cut off, normally it will need 200s almost. so it would choose the power controller which has input and reput lock time function after cut off the power. If choose normally power controller, it must install speediness discharge power equipment. it would not limited which use adopting same electric factor input and chip switch. 2. Altitude level is not more than 200...

Function and features 1. Measure active electric energy, no need of calibration for long-term operation; 2. Adopt dedication meter age chip ADE7755; 3. Adopt lasted electricity dedication integrated circuit including digital multiplier overseas, greatly improved dynamic working range of Meter, making 1 multiple actual overload; 4. Have a good mistake linearity at a range of 5%Ib~Imax; 5. Few periphery component, simple structure, low power consumption; 6. Adopt high reliability and long life ...

Function and features 1. Measure active electric energy, no need of calibration for long-term operation; 2. Adopt dedication meter age chip ADE7755; 3. Adopt lasted electricity dedication integrated circuit including digital multiplier overseas, greatly improved dynamic working range of Meter, making 1 multiple actual overload; 4. Have a good mistake linearity at a range of 5%Ib~Imax; 5. Few periphery component, simple structure, low power consumption; 6. Adopt high reliability and long life ...

Scope EP mainly used for electrical equipment cabinets or three-phase asynchronous motor load start shifting and steering, used as the main and auxiliary circuits conversion, can fully replace other switch. Type Designation Main Technical Parameters Dimensions and Mounting Dimensions Dimensions and Mounting Dimensions

Operation and installation condition 1. Installation altitude≤2000m 2. Ambient air temperature -5℃ ~+40℃ average temperature of 24 hours must below +35℃ 3. Relative humidity below 90% when the temperature is +25℃±5℃ 4. Ambient pollution level: 3 5. Installation category of the starter: III Acting characteristic of each phase in distribution circuit breaker in the load balanced condition

Working Conditions 1. Power capacitor should confirm left voltage reduce to rated voltage 10% to input again after the power was cut off, normally it will need 200s almost. so it would choose the power controller which has input and reput lock time function after cut off the power. If choose normally power controller, it must install speediness discharge power equipment. it would not limited which use adopting same electric factor input and chip switch. 2. Altitude level is not more than 200...