General

IEC60647-6(1999)/GBI14048.11-2002 “low voltage switchgear and control equipment multifunctional no.1:automatic transfer switches”

Control device:built in controller
Product structure:no power off,guide rail type,high current,small volume,two-stage type, simple structure,ATS integration
Features:fast switching speed,low failure rate,convenient maintenance and reliable perfomance
Wiring mode:front plate wiring
Conversion mode:power grid to power grid,power grid to generator,photovoltaic to urban power,automatic switching and self recovery
Product frame:100
Product current:10,16,20,25,32,40,50,63,80,100A
Product classification:direct load type
Pole No.:2,3,4
Standard:GB/T14048.11
A T S E:PC class
Switching time:0.008s/8ms

Normal operation time and installation conditions

Ambient air temperature
The maximum temperatu re shall not exceed 40°C the minimum temperature shall not be lower than -5°C,and the average temperature within 24 hours shall not be higher tehan 35 °C.
Altitude
The altitude of the installation site should not be higher than 2000m.
Atmosphenc conditions
When the maximum temperature reaches 40°C,the telative humidity of the installation site should not exceed 50%;when the temperature is the minimum tem -perature -5℃,the relative humidity is higher,for example,the temperature is 25℃, and the relative humidity is 90%.Due to the temperature change,special measures should be taken to deal with the occasional condensation on the surface of the product.
Pollution grade
The pollution grade of ATS conforms to grade 3 specified in GB/T14048.11.
Installation category
The installation type of ATS confoms to the category specified in GB/T14048.11.
Installation conditions
ATS can be installed vertically in control cabinet or distribution cabinet.Make sure the installation distance meets the requirements in Figure 8.